2,910
(latest NCVER data)UEERL0005 Locate and rectify faults in low voltage (LV) electrical equipment using set procedures prepares learners to diagnose and correct faults in low voltage equipment by following set procedures, safe work method statements and wiring diagrams. It is a sensible scope choice for RTOs whose learners carry out restricted electrical fault-finding alongside their main trade, and UEERL0005 RTO training resources give trainers a clear sequence to follow.
Learners develop skills in preparing to identify faults, applying safe LV work practices, interpreting wiring diagrams, using routine fault-finding techniques and test equipment, rectifying faults, dealing with unplanned events and completing reports.
Start with our UEERL0005 RTO training materials instead of writing LV fault-finding content from the beginning. Purchase RTO materials and use the UEERL0005 learning materials to keep delivery structured and safety-focused.
Inside the UEERL0005 training resources is a prepared foundation for locating and rectifying faults in LV electrical equipment. Purchase RTO materials to reduce internal workload, with UEERL0005 training materials organised around preparation, diagnosis and rectification.
Check the latest unit requirements on training.gov.au before delivery. Your team should contextualise and validate these UEERL0005 training materials for its learner cohort, delivery model and selected compliance environment. Use the supplied mapping as a starting point when reviewing your UEERL0005 materials against the Standards for RTOs.
UEERL0005 Locate and rectify faults in low voltage (LV) electrical equipment using set procedures focuses on following workplace procedures to inspect, test and repair faults in low voltage electrical equipment. It applies where this work is incidental to a primary or regular workplace function, within the exclusions described in the range of conditions.
The unit addresses five core areas:
Yes. The Class Activities Book and assessment tasks use practical scenarios that require learners to follow a set fault-finding sequence, interpret wiring diagrams and confirm the repair through testing.
Yes, provided your simulated equipment reflects the LV faults described in the unit and assessors can observe safe isolation and testing. Your team should confirm the setup meets the assessment conditions.
The Learner Guide and Self-study Guide introduce common symbols and diagram layouts so learners can trace circuits before they attempt practical fault-finding. Trainers can add diagrams for equipment used at their own sites.
They are developed as compliant learning resources, but they do not guarantee regulatory compliance or audit outcomes. Restricted licensing requirements differ between states and territories, so your organisation should confirm them before delivery.
No. The unlimited student licence allows the purchasing organisation to use the materials with all enrolled learners without per-student fees, subject to the applicable licence conditions.
By submitting this form, you agree to the TotalVET Training Resources Privacy Policy.
UEERS0020 Apply rail signalling principles
UEERS0021 Assemble and wire electrical rail signalling equipment
UEERS0022 Find and repair rail signalling system faults
UEERS0023 Inspect, test and certify rail power signal equipment
UEERS0024 Install and maintain rail track circuit leads and bonds
UEERS0025 Maintain active level crossing equipment





