685
(latest NCVER data)UEEIC0029 Set up and adjust PID control loops prepares learners to check, isolate and adjust process controllers, transmitters and converters so control loops hold a process at its intended set-point. It is a sensible scope choice for RTOs whose instrumentation learners work on process plant, and UEEIC0029 training resources support the theory behind PID modes and loop behaviour.
Learners develop skills in obtaining the scope of control problems, coordinating work with supervisors, determining the need to test live work, isolating controllers and loops, using measured and calculated values to solve loop problems and completing status reports.
Equip your trainers with our UEEIC0029 RTO training materials rather than building PID tuning content internally. Purchase RTO materials and use the UEEIC0029 learning materials to move learners from loop principles to practical adjustment.
These UEEIC0029 training materials provide a prepared foundation for setting up and adjusting PID control loops. Purchase RTO materials and give trainers UEEIC0029 RTO training materials that link controller theory with practical loop work.
Check the latest unit requirements on training.gov.au before delivery. Your team should contextualise and validate these UEEIC0029 training materials for its learner cohort, delivery model and selected compliance environment. Use the supplied mapping as a starting point when reviewing your UEEIC0029 materials against the Standards for RTOs.
UEEIC0029 Set up and adjust PID control loops covers setting up and adjusting proportional-integral-derivative control loops, including evaluating loop performance and solving control problems. It applies to workers who check, isolate and adjust process controllers, transmitters and converters.
The unit addresses five core areas:
The learning content introduces proportional, integral and derivative functions, controller options, reset windup and direct and reverse acting controllers before learners adjust loops. Trainers can add trend data from their own process rigs.
Learners need a process rig or plant with controllers, transmitters and converters that can be isolated, tested and adjusted. The unit also notes that a licence or permit to practise applies to electrical work above 50 V a.c. or 120 V d.c.
Yes. The Trainer Assessment Pack/Marking Guide gives assessors reference points for judging problem solving and status reporting. Assessors should add acceptable loop responses based on the equipment used.
Yes. They are developed with training package requirements in mind, but your organisation should review and validate them for its learners and facilities before delivery.
No. The unlimited student licence allows use with all enrolled learners without per-student fees, subject to the applicable licence conditions.
By submitting this form, you agree to the TotalVET Training Resources Privacy Policy.
UEEIC0030 Set up and adjust advanced PID process control loops
UEEIC0031 Set up and configure humanmachine interface (HMI) and industrial networks
UEEIC0032 Set up electronically controlled robotically operated complex systems
UEEIC0036 Set up water analysis measuring and control instruments
UEEIC0038 Solve problems in density/level measurement components and systems
UEEIC0039 Solve problems in flow measurement components and systems





