2,655
(latest NCVER data)Industrial and mining sites rely on workers who have completed UEERL0002 Attach cords, cables and plugs to electrical equipment for connection to 1000 V a.c. or 1500 V d.c. to terminate multi-phase cords, cables and plugs that must withstand heavy loads, damp areas and demanding service duty. It suits RTOs building electrical pathways that move beyond single phase work, and UEERL0002 training materials give trainers a structured base for this higher-voltage content.
Learners develop skills in planning connection work, selecting multi-phase cords, cables and plugs by rating, core count and IP rating, preparing and terminating conductors, earthing and polarity checks, inspecting and testing equipment, locating and repairing faults and providing status reports.
Equip trainers with our UEERL0002 RTO training materials and avoid developing multi-phase connection resources from the ground up. Purchase RTO materials and use the UEERL0002 training resources as a ready framework for workshop and assessment tasks.
This package of UEERL0002 RTO training materials provides a prepared foundation for attaching cords, cables and plugs to equipment on higher-voltage supplies. Purchase RTO materials and begin with UEERL0002 training materials organised for both theory and practical delivery.
Check the latest unit requirements on training.gov.au before delivery. Your team should contextualise and validate these UEERL0002 training materials for its learner cohort, delivery model and selected compliance environment. Use the supplied mapping as a starting point when reviewing your UEERL0002 materials against the Standards for RTOs.
UEERL0002 Attach cords, cables and plugs to electrical equipment for connection to 1000 V a.c. or 1500 V d.c. covers attaching flexible cords, cables and plugs to electrical equipment connected to supplies up to 1,000 V a.c. or 1,500 V d.c. It applies to electrical workers who plan, connect, test and repair multi-phase connections in line with industry standards and workplace procedures.
The unit addresses five core areas:
The content focuses on multi-phase systems, higher current ratings, core and pin requirements, IP ratings and colour codes for supplies up to 1,000 V a.c. or 1,500 V d.c. Learners work with heavier cords, cables and industrial plugs rather than standard single phase fittings.
The unit notes that a relevant contract of training, such as an Australian Apprenticeship, may apply where a licence or permit is not held. The UEERL0002 resources support delivery, but your team must confirm supervision and licensing arrangements in your state or territory.
Yes. The Student Assessment Pack and Trainer Assessment Pack/Marking Guide are structured around repeatable practical tasks, and the mapping shows how evidence links to the unit requirements. They are developed as compliant learning resources, but they do not guarantee audit outcomes.
Yes. The editable files allow your team to reference the plugs, sockets, cable types and site procedures your learners will use, while keeping the unit evidence requirements intact. These RTO resources can also carry your organisation’s branding.
Yes. Lifetime updates are supplied under the applicable product terms, so qualifying updates can be accessed without purchasing the same product again.
By submitting this form, you agree to the TotalVET Training Resources Privacy Policy.
UEERL0003 Conduct in-service safety testing of electrical cord connected equipment and cord assemblies
UEERL0004 Disconnect - reconnect electrical equipment connected to low voltage (LV) installation wiring
UEERL0005 Locate and rectify faults in low voltage (LV) electrical equipment using set procedures
UEERS0020 Apply rail signalling principles
UEERS0021 Assemble and wire electrical rail signalling equipment
UEERS0022 Find and repair rail signalling system faults





