5
(latest NCVER data)In boat building and marine servicing, an engine or drive that is poorly aligned or incorrectly coupled can cause vibration, wear and failure at sea; MEM25011 Install marine systems develops the ability to install, align and test engine/plant and ancillary equipment correctly. For RTOs delivering marine trade qualifications, it fills a need for hands-on installation training, supported by MEM25011 learning materials that cover propulsion, steering, stability and fuel systems.
Learners develop skills in interpreting specifications and Australian Standards, checking and preparing installation sites, installing and levelling engine/plant components, aligning and coupling drives, testing operation, interpreting fault indicators and planning corrective action.
Choose our MEM25011 RTO training materials and avoid developing marine installation resources internally. Purchase RTO materials and give trainers MEM25011 training resources that follow an installation job from site preparation to test results.
This package of MEM25011 RTO training materials provides a prepared foundation for installing marine systems. Purchase RTO materials to reduce preparation time and start with MEM25011 learning materials ready for your workshop and vessel arrangements.
Check the latest unit requirements on training.gov.au before delivery. Your team should contextualise and validate these MEM25011 training materials for its learner cohort, delivery model and selected compliance environment. Use the supplied mapping as a starting point when reviewing your MEM25011 materials against the Standards for RTOs.
MEM25011 Install marine systems covers installing and testing engine/plant and ancillary equipment for propulsion, stability, steering and fuel systems on mechanically powered marine vessels, excluding outboard motor installation. Work can take place in a workshop or on site, with vessels moored or in a sea-trial situation.
The unit addresses five core areas:
Learners must install and test engine/plant on at least two occasions, so access to a marine workshop, vessels and suitable test equipment is needed. Electrical connections are made by an appropriately qualified person, not the learner.
Where technical drawings or load shifting equipment are involved, the unit notes that relevant drawing or load shifting units should also be selected. Your team should plan this when building the qualification structure.
Yes. The editable files allow trainers to include the engine, drive and coupling specifications used by their industry partners.
There is no learner cap. The unlimited student licence covers enrolled learners without ongoing per-student fees, subject to the applicable licence conditions.
No. They are developed with training package and compliance considerations in mind, but they are not a guarantee of compliance or audit outcomes, and your organisation should validate them before delivery.
By submitting this form, you agree to the TotalVET Training Resources Privacy Policy.
MEM25012 Install and test operations of marine auxiliary systems
MEM25013 Produce three-dimensional plugs/moulds
MEM26001 Lay up composites using open moulding techniques
MEM26006 Mark and cut out sheets for composite use
MEM26007 Select and use reinforcing appropriate for product
MEM26008 Select and use resin systems appropriate for product





